The difference between both products focused on the composition of the rubber magnet wich magnetic force changes second the part of the 4x4 protected.
In order to help you in your choice, please check datas below.

Storage :
If possible, store the elements flat, all elements facing the same way, otherwise.
Keep in a dry place and do not forget to dry the elements properly before storage.

Spare parts :
It is possible to re-order any elements separatly.
For any further questions, please contact us.

Install each element on a clean surface. Be sure to install all the rubber magnet elements correctly.
Make sure that the rubber magnet covers the car bodywork evenly.
When fitting the elements, make sure you leave a space of at least 5 mm from the edge.
With time, due to temperature changes, the elements could retract ( +/- 2% at least per metre )

Start with the doors, working from top to bottom.
Then continue with the other elements following the same process.
Lastly, install the small elements.
Don' t forget to clean both sides of the Protec Magnet before and after use.

The elements cannot be used when driving at high speeds.

Please reffer to the conditions of use in the price list.

When the temperature is very cold, it could be more difficult to install the elements for the front mud guards. Just press them on with your hands.

Should the Protec Magnet distort, place it in a warm place. After in few mintues it will warm up and then you can install it on the vehicle.

Do not place any electronic device ( telephone, GPS, computers, … ) on the magnet as this could interfare with functionment. ( this does not affect equipment inside the vehicle ).

When the outside temperature is very high ( up to 35°C ), we do not recommend that you use the Protec Magnet. Rubber tends to melt at 70°C and it could stick to the paintwork. If this should happen, you would need to re-polish the paintwork.

Infrared Thermometer